Re: Removing injectors....

[Eric L Ellis <elf16v@juno.com>]

On Sat, 08 Apr 2000 17:23:28 -0700 Tyler Zachau <Pennyz@mail.ieway.com>
writes:
> How do I remove the injectors on a 16v motor? Certainley there must 
> be more
> to it than yanking on them... TIA!
> Tyler

DO NOT YANK OR SIMPLY PULL! Use a long screw driver or pry bar behind the
line coupling AFTER you twist the injector. Buy this I mean, rotate it
back and forth to dislodge it from its seat. (clock wise and counter
clock wise as standing at the front of the car) Then use the lever action
as you pull with even pressure on the line as close to the point where it
makes a 90º toward the injector.

Eric
Good, bad....I'm the guy with the gun!

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org