[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: SV: performance strut bearing question
Where do you get those Roland?
And how much are they?
Eric
On Fri, 22 Oct 1999, Roland Johansson wrote:
> Bonrath reinforced bearings. Can handle the abuse of lowered car and still last. Same design as Autotechs reinforced but other material inside, should be same quality.
>
> Rocks
>
> Roland Johansson, Swedish Viking
> Scirocco 1,8lT RSi -82
> Http://hem.passagen.se/toker
>
> ----- Ursprungligt meddelande -----
> FrĀn: <Vaughn8v@aol.com>
> Till: <scirocco-l@scirocco.org>
> Skickat: den 22 oktober 1999 04:38
> mne: performance strut bearing question
>
>
> > Which is a good aftermarket strut bearing? Autotech? Does it affect at all
> > the ride height (stance) of the vehicle? Is it worth the $$, or are standard
> > VW strut bearings sufficient? I just bought HOR springs, and am going to buy
> > Boge struts, and I have been pondering the strut bearing idea. Either way I
> > think that I am going to replace them. Also, anybody had experiences with
> > the polyeurethane control arm bushing, etc.? Worth the moolaa?
> >
> > Ben
> > 88 "Flash Silver Metallic" 16v Scirocco
> >
> > --
> > Email problems to: scirocco-l-probs@scirocco.org To unsubscibe send
> > "unsubscribe scirocco-l" in the message to majordomo@scirocco.org
> >
>
>
> --
> Email problems to: scirocco-l-probs@scirocco.org To unsubscibe send
> "unsubscribe scirocco-l" in the message to majordomo@scirocco.org
>
--
Email problems to: scirocco-l-probs@scirocco.org To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org