[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: loose break cable



Nah, I just worked the rear brake hardware off of the top pin next to the wheel cylinder
and was able to tilt the whole assembly out about25-30 degrees or so, that freed
everything up enough for me to work on the cable and lever.

Greg


> One end goes into a little lever in the brake, and the
> >other end screws into the hand brake.  It's not hard, but I think you
> do
> >have to pull the springs off the brake to do it.  That can be kinduva
> PITA.
> > Once done, I usually pull the brake where I want it, then see if I can
> >spin the wheel... if I can still spin it, I take up a little slack at
> the
> >parking brake, and go back and spin, and so on.
> >
>


--
To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
If you experience other problems, email: scirocco-l-probs@scirocco.org