Re: Wheel noise

["Jorel Jackson" <kondor77@hotmail.com>]

>Rich Deede wrote:
>
>> Now do I need the special wheel bearing pulling tool to do the rears? 
I
>> looked in the Bentley and it didn't look like I needed it.  But it 
did
>> mention something about a press.  What is this about? And since I 
don't
>> have access to a press, is there any alternative to this?  And 
finally,
>> how hard are the rear wheel bearings as compared with the front?

Yes, both front and rear wheel bearings need to be pressed. This 
requires a special tool;however, this tool can be built at home with 
scrap aluminum. I have a picture of one if you would like. And it would 
not suprise me if someone else out there has already built one of these 
tools.

JSJackson '85 Scirocco

______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com

--
To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
If you experience other problems, email: scirocco-l-probs@scirocco.org