Re: Shifter Bushings

["Gerry Reichelt" <reichelt@telepath.com>]

----- Original Message -----
From: Dale Witt <Dalewitt@express-news.net>

> Maybe this subject has been discussed before............if so, I had a
brain fart and do
> not remember.  Problem is that my headers on both rocs put off a lot of
heat and are
> very close to the shifter linkage and as a result I go through bushings
much too often.
> Is there a source for replacement bushings that hold up under heat better
than the
> run of the mill replacement bushings?  They are cheap, but it is a hassle
to replace
> them every 6 to 12 months.
    Seems like there were some delrin bushings as well as brass bushings
mentioned awhile back. Don't remember vendors. Reformatted hard drive caused
my CRS syndrome(can't remember shit)
Gerry


--
To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
If you experience other problems, email: scirocco-l-probs@scirocco.org