[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Source for Pistons/and some ?s
if you are goign to overbore it i believe you are going to have to
mahine the block.....i can do 83mm with out a problem....
i changed teh crank at 83.5 to get a 2.1L
Testastrega@aol.com wrote:
>
> If you go to oversized pistons on a 2.0 16V will that require any machining
> to the block? Such as a over-bore. How about conflicts with the rods and
> crank?
>
> Shannon
> "Better to burn out than to fade away"
> 87 16V w/210,000 mi.
--
Email problems to: scirocco-l-probs@scirocco.org To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org