Re: Wiring Harness to Radiator

[Shawn C Meze <skerocdriver@juno.com>]

On Thu, 23 Dec 1999 23:39:23 -0500 Jim Jarrett <jarrett@rpa.net> writes:

>Can't you just cut back to some decent wire, solder in a new piece 
>and crimp on and solder a new spade connector?
>
>I've had to do that before....it works.


I was going to recomend that very thing. Why not just splice in using
butt (heh-heh) connectors and a good piece of heat shrink tubing? Works
just fine and it saves you the extra work of swaping out the entire
harness. 


Shawn Meze
86' Jetta GLi   82' Scirocco GTi   81' "Project Scirocco FSP"
The Fastest, Quickest, Cleanest and
best looking Scirocco in all of San Diego!
http://www.Geocities.com/MotorCity/Speedway/1308/index.htm 

________________________________________________________________
YOU'RE PAYING TOO MUCH FOR THE INTERNET!
Juno now offers FREE Internet Access!
Try it today - there's no risk!  For your FREE software, visit:
http://dl.www.juno.com/get/tagj.

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org