Re: Dremel Tool for porting?

["Dave and Carol Ewing" <dcewing@prodigy.net>]

<x-charset iso-8859-1>Totally depends on what you are porting.  I ported my 16v head (basically
smoothed things out) and port-matched the intake manifolds.  I ported and
polished my TB too but I used an air die grinder since there had to be a
bunch of alum. removed.  If you are going to take ALOT of material off, I'd
suggest an air die grinder, if you don't have access to either air or a die
grinder, then get a few carbides for your dremmel.  One course, one med. and
one finer.  Not too fine because aluminum with clog it up and the tip will
be not good to you.  You could clean it, but it will just get clogged again
and again. HTH!!

Dave


--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org


</x-charset>