Re: Side mount

["Chris DeLong" <green536@hotmail.com>]

slight correction: 6mm not 8mm allen. :-)


>From: T Berk <tberk@mindspring.com>
>To: Michael Friesen <mfriesen@sympatico.ca>
>CC: Scirocco List <scirocco-l@scirocco.org>
>Subject: Re: Side mount
>Date: Thu, 12 Aug 1999 22:11:51 -0700
>
>Michael Friesen wrote:
> >
> > How hard is it to replace a timing belt side motor mount?  What is 
>involved?
> > What tools do I need to get from the local Canadian Tire?
> >
> > Thank,
> >
> > Mike
> > 85 8v
>
>Jack Stands to hold up car
>Floor Jack to hold up engine
>8 MM Hex Allen type wrench (might need trimming to fit)
>13 mm Open end wrench (Good High quality tools are good)
>Liquid Wrench
>New Motor Mount pre pressed into bracket by the Potter dude.
>
>Stuff that might help but is not absolutely ness.:
>
>Needle nose Vice Grips
>Replacement bolt(s) to replace the Hex Socket Bolt(s) you take out
>Rear & Front & Trans side mounts to replace as well. :)
>
>TBerk
>
>--
>To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
>If you experience other problems, email: scirocco-l-probs@scirocco.org
>


Chris DeLong
ICQ#45030867
'80 16V Rag
'65 Bus (ugly, but good for campin' W/toaster oven)
'82 GLI
'80 'Vert
'80 PU (slammed to the curb)
'61 17 Window




_______________________________________________________________
Get Free Email and Do More On The Web. Visit http://www.msn.com

--
To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
If you experience other problems, email: scirocco-l-probs@scirocco.org