Re: 2.0L 16V

["Mike & Kristen Potter" <kmpotter@ix.netcom.com>]

----------
> From: KDBinney@aol.com
> To: 104372.1061@compuserve.com; tudor@tvo.org; ay455@lafn.org;
scirocco-l@privatei.com
> Subject: Re: 2.0L 16V
> Date: Thursday, April 03, 1997 7:05 PM
> 
> On the back of any 2.0 (assuming it not a bored out 1.8) there is a cast
> "2.0" in the back of the block.  Same with a 1.8 (no it doesnt say 2.0).
 
> 
> Or you could go by the engine code on the front of the block
> PL is a 1.8 16v
> 3A(I think, something like that) is a 2.0 16v
> 
> Kyle

Also the 2.0 blocks are all "bubble blocks" there is a bulge where each
cylinder is on the lower part of the block.
The 2.0 engine code is a 9A (not to be confused with the 8V trans code
9A,85-88) 

Potterman 



> --
> To subscribe or unsubscribe, send email to
scirocco-L-request@privateI.com,
> with your request (subscribe, unsubscribe) in the BODY of the message.
--
To subscribe or unsubscribe, send email to scirocco-L-request@privateI.com,
with your request (subscribe, unsubscribe) in the BODY of the message.