[OT] 1990 Jetta, Are you freaking kidding me????!!!

[peter at thescirocco.com (Peter)]

Yeah, it's relatively easy...

Unbolt the thin top bracket and remove it, unbolt the 2 - 13mm(head-size)
bolts, and lift the rear mount out of the cup in the sub-frame. IIRC, you
will need a wobble joint, or an extension with a wobble on the end.

How's the front mount, they're usually not far behind?

HTH!

Peter 

-----Original Message-----
From: Allyn [mailto:amalventano1@xxxxxxx] 
Sent: Friday, July 13, 2007 12:15 PM
To: 'Jason F. Snow'; 'Scirocco List'
Subject: RE: [OT] 1990 Jetta, Are you freaking kidding me????!!!

Raise the tranny and remove the bracket from it.  That's the best way I can
think to get it out of the way.  The alternative is to drop the entire
subframe.

Al 

> -----Original Message-----
> From: Jason F. Snow [mailto:Jason@xxxxxxxxxxxxxxxx]
> Sent: Friday, July 13, 2007 11:13 AM
> To: Scirocco List
> Subject: [OT] 1990 Jetta, Are you freaking kidding me????!!!
> 
> Dudes and Dudettes,
> 
> WTF - Does anyone know how to remove the drivers side tranny mount in 
> the back? It's a 5 speed 8 Valver.
> 
> I cannot believe it, it looks like you have to remove the axle?
> 
> I jacked the tranny so high that it was touching the body!!! 
> And that's not good.
> 
> The mount is hydraulic and is way taller than the replacement mount 
> (G60 non hydraulic).
> 
> Any suggestions?
> 
> I'm beat down and bewildered.
> 
> Jason
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@xxxxxxxxxxxx
> http://neubayern.net/mailman/listinfo/scirocco-l


_______________________________________________
Scirocco-l mailing list
Scirocco-l@xxxxxxxxxxxx
http://neubayern.net/mailman/listinfo/scirocco-l