[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Header issues - 8V



Most of the VW I've had did use a similar shield.

-----Original Message-----
From: Dan Bubb [mailto:jdbubb@verizon.net] 
Sent: Wednesday, February 21, 2007 8:23 AM
To: Cory Langford; Scirocco list
Subject: Re: Header issues - 8V

The MK IV 1.8T engine came with a really nice little heat shield that
bolted to the back of the engine and curved up over the inner CV boot.
You can see a picture of it here:
http://i9.photobucket.com/albums/a95/jdbubb/Misc/Dsc00590.jpg
Anyway, I believe the bolt holes in the back of the 1.8T block are the
same as the early 4 cylinder engines.
Dan

From: "Cory Langford" <Cory_Langford@bcit.ca>
To: "Scirocco list" <scirocco-l@scirocco.org>
Sent: Tuesday, February 20, 2007 3:15 PM
Subject: Header issues - 8V


> 
> 
> Well, I have a header (no clue which brand as it was attached to a
parts
> car I bought) that seems to be causing the cv boots to fail.
> 
> The header is a 4 into 1 model, and the collector that all 4 pipes run
to
> is close to the inner cv.  The first time the cv boot actually melted,
so I
> wrapped the header and installed a new cv boot.  This time it lasted
> longer, but it is very brittle again and is cracking.
> 
> I was just wondering if there were brands of headers for an 8V that
address
> this issue?  Which brand do you use and do you have a problem with
heat
> affecting the inner cv boot
> ?
> 
> TIA
> 
> Cory


------------------------------------------------------------------------
--------


> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>


_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l