[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

WTB: Climate control controls



Drill the center point out and use a bolt with nylon locking nut to secure it. Then replace the cable and check the movement of the diverter valve near the firewall.
That should do the trick. Have fun in this weather :)

>-----Original Message-----
>From: Nate Mellom [mailto:doubt@inwave.com]
>Sent: Tuesday, October 31, 2006 10:34 PM
>To: 'Scirocco list'
>Subject: WTB: Climate control controls
>
>My air distribution/temperature selection controls were always sticky, a 
>while ago the upper slider busted completely (at the pivot, not just the 
>plastic slider), and the lower is stuck on hot, which is okay (it's 
>getting cold in the mornings!), but I can't select where the air goes. 
>It's somewhere between floor and vent, and recently, I've needed defrost.
>
>Anyone parting? I need the whole shebang, everything behind the dash, 
>and maybe the plastic sliders if ya got 'em.
>
>And an update on the nasty running. Swapped in a new cap and rotor, 
>started like nobody's business. Drove it today for the first time in 2 
>weeks, and it was good! Nest time it's humid/raining, I'll do some 
>exploritory laps around the block (so's not to be too far from home).
>
>Nate
>'88 16v w/AC
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l
>