MS diagram?

[vw_85roccoZ400 at hotmail.com (Brian Spinney)]

Marc,

Yeah they just came out with it back in May!  I was the first on their order 
list.  I have pictures of it installed on my car at home that I can email if 
you would like to see them.

However you may run into a few problems trying to run it on your 8v so I 
will give you a little heads up.

1. If you don't have power steering, you will need a power steering bracket. 
I can mod you up one if you don't have one for a few dollars.  (I had to do 
this for my car). It uses the PS bracket for mounting.

2. You will need the 16v pulleys and lower timing gear like I said before. 
Or if you don't want to spend $125 on the gear and you have the pulley I can 
make you a spacer for less than 1/2 the price of the gear.

3.  One last problem you will run into is with the trigger wheel on the 
crank pulley you won't be able to get at the 19mm nut to turn the motor 
over.  You could use the cam nut but that isn't recommended.  I am in the 
process of making a tool for there trigger wheel assembly.

Thanks
-Brian

85 Scirocco 8vT       01 Jetta 20vT       84 Rabbit GTI


----- Original Message ----- 
From: "Mtl-Marc" <marc_scirocco@sympatico.ca>
To: "'Brian Spinney'" <vw_85roccoZ400@hotmail.com>; "'Org, Scirocco'" 
<scirocco-l@scirocco.org>
Sent: Tuesday, July 25, 2006 2:18 PM
Subject: RE: MS diagram?


> Thanks for the info, this is what I am looking for.
>
> I found it on their web site. <<http://tinyurl.com/jyp35>>
>
> Not that expensive if you figure that you have no leg work to do. Its all
> there.
>
> Thanks again.
>
> Marc
>
>
>>
>> 034 efi sells a 16v trigger wheels setup.  All that would be
>> needed is the 16v crank pulley and bigger lower timing belt
>> gear.  It will run you $200 though.
>> -Brian
>>
>> 85 Scirocco 8vT       01 Jetta 20vT       84 Rabbit GTI
>>
>> ----- Original Message -----
>> From: "Mtl-Marc" <marc_scirocco@sympatico.ca>
>> To: "'Org, Scirocco'" <scirocco-l@scirocco.org>
>> Sent: Saturday, July 22, 2006 1:08 PM
>> Subject: RE: MS diagram?
>>
>>
>> > --snip--
>> > Mr Bubb said:
>> >> ... hall sensor input and now that I think about it you ain't
>> >> using that anyway since you're going to be using a crank trigger.
>> >>
>> >
>> > How do you install a crank trigger on a vw motor?
>> >
>> > I am building a stroker 8V motor, and after seeing Timbo's
>> demonstration
>> > at
>> > Cincy, I am sure this is a cool project for me to do. By
>> trade I am an
>> > electronic tech, so wiring, soldering, etc is just about
>> second nature to
>> > me
>> > :-)
>> >
>> > Cheers.
>> >
>> > Marc
>> >
>> >
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>