MS diagram?

[marc_scirocco at sympatico.ca (Mtl-Marc)]

Thanks for the info, this is what I am looking for.

I found it on their web site. <<http://tinyurl.com/jyp35>>

Not that expensive if you figure that you have no leg work to do. Its all
there.

Thanks again.

Marc 


> 
> 034 efi sells a 16v trigger wheels setup.  All that would be 
> needed is the 16v crank pulley and bigger lower timing belt 
> gear.  It will run you $200 though.
> -Brian
> 
> 85 Scirocco 8vT       01 Jetta 20vT       84 Rabbit GTI
> 
> ----- Original Message -----
> From: "Mtl-Marc" <marc_scirocco@sympatico.ca>
> To: "'Org, Scirocco'" <scirocco-l@scirocco.org>
> Sent: Saturday, July 22, 2006 1:08 PM
> Subject: RE: MS diagram?
> 
> 
> > --snip--
> > Mr Bubb said:
> >> ... hall sensor input and now that I think about it you ain't
> >> using that anyway since you're going to be using a crank trigger.
> >>
> >
> > How do you install a crank trigger on a vw motor?
> >
> > I am building a stroker 8V motor, and after seeing Timbo's 
> demonstration 
> > at
> > Cincy, I am sure this is a cool project for me to do. By 
> trade I am an
> > electronic tech, so wiring, soldering, etc is just about 
> second nature to 
> > me
> > :-)
> >
> > Cheers.
> >
> > Marc
> >
> >