Of flywheels, transmissions and engines

[jdbubb at verizon.net (Dan Bubb)]

The 020 clutch/flywheel is sort of inverted from a normal setup. Normally the flywheel bolts to the crank and the PP bolts to that. For the 020 the PP bolts to the crank and the flywheel bolts to that. So, no, the G60 flywheel will not work with the 020 tranny.
The 7A is not a "16V" tranny. i.e. it doesn't have the bigger input shaft or bigger 4th gear splines. It's a super wide ratio tranny w/3.94 final drive that was installed in Rabbits and Jettas from 82 to 84.
Dan

From: "Rhett Farnum" <rocco.crossing@gmail.com>
Sent: Thursday, February 09, 2006 12:37 AM

Dumb question but is a 7A a 16V tranny or what? Not sure I have heard or
seen one yet.

Rhett

On 2/8/06, Phil Boeye <rocco_phil@yahoo.com> wrote:
>
> So I'll be running a PG block (G60) w/ a 7A
> transmission (most likely).
>
> Now the question is, will the lightened G60 flywheel
> (Eurospec) that I picked up work?  I had gotten this
> when I was thinking about a 02A swap (silly me).
>
> But now now sure the G60 flywheel will work with the
> 020 transmission.
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>
_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l