16v head gasket Q

[tyrone27 at gmail.com (Derrick floyd)]

u have to pull the head and replace the headgasket and bolts.  they are
streached bolts so can't reuse them.  and headgasket is a one time use only
one unless its metal then u "might" be able to reuse it.  pull the head get
it decked and clean the surface on teh block and re install.

On 8/28/06, Daun Yeagley <vwdaun@yahoo.com> wrote:
>
> Long story short, it looks like my head gasket on my 16v is
> leaking oil down the back of the block at the passenger
> side corner.
>
> So the question is, do I just go and re-torque the head
> bolts, or pull the head?  The head was off about 3 years
> and probably as many thousand miles ago (if that,
> truthfully.)  It's a stock 2.0 block & head.  I'm just
> wondering if I didn't get it torqued properly, as it wasn't
> long after install that I noticed the leak.  (I don't know
> if it was leaking before.)
>
> Opinions?  I'm part-way into disassembly.  If I do pull the
> head, how can I check to make sure it's in good shape?  I'd
> hate to put a new gasket on only to find the same problem
> cropping up again.
>
> Thanks for any suggestions....
>
>
> Daun Yeagley - Wilmington Ohio
> '80 Scirocco                 '81 Scirocco S 16v to be?
> '86 Scirocco 8v              '88 Scirocco 16v
> '88 Scirocco Slegato (Gino!) '96 Passat GLX Wagon
> '56 Cessna 172
> The first rule of intelligent tinkering is to save all the parts -
> Ehrlich's Law.
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>