my installation/driving impressions

[rocco16 at sbcglobal.net (LEF)]

Oh.

larry
sandiego16v
  ----- Original Message ----- 
  From: David Utley 
  To: LEF 
  Cc: scirocco-l@scirocco.org 
  Sent: Friday, August 11, 2006 5:20 PM
  Subject: Re: my installation/driving impressions


  I was ribbing you, Larry...   :-)

  David

  LEF wrote:
  > I fail to see the correlation.
  > Enlighten me?
  >  
  > larry
  > sandiego16v
  >
  >
  >     LEF wrote:
  >     > Spherical rod end linkage is very little improvement over new
  >     stock plastic ball-in-socket pivots, since there is little/no play
  >     in the stock setup.
  >     >  
  >     > The biggest improvement in the shift linkage comes from putting
  >     solid, low-tolerance bushings everywhere you can replace the stock
  >     polyurethane units, which quickly go south from oil/heat.
  >     >
  >     > I put the complete MissingLinkz kit on mine (minus the weighted
  >     link) and found the above to be true.
  >     >  
  >     If this is true, then it is no wonder you saw no improvement with the
  >     addition of stressbars...  :-P
  >
  >     David
  >