Shine rear swaybar dimension & metallurgical advice needed + (ATTN: Ron P.

[amalventano1 at tds.net (Allyn)]

I seem to remember Rons bar mounting further inboard, (to the flat part, just before the tubing).  Either way, this bar seems like
it would work better.  That piece seems to be doing a little more than just twisting under the load.  I wonder if attaching it at
the center (with spacers) would be prudent.


  _____  

From: Don Walter [mailto:dswalterwi@gmail.com] 
Sent: Sunday, August 06, 2006 1:53 PM
To: Ron Pieper
Cc: Allyn; Mark F.; scirocco list; Rick Kellner; Jason
Subject: Re: Shine rear swaybar dimension & metallurgical advice needed + (ATTN: Ron P.


Here are pictures of the Ron and Ben's Rear Axle Bar.  Hope they are good as I had to Jack my car way up to get them.  You may see
some torsional effect of the bar from being jack up from one side.  Hope this helps everyone. 
 
http://scirocco.dyn.dhs.org/vw/list/Don_Walter/RearAxle-Shrine/