Since its slow....

[julie at menloparkrandd.com (julie@menloparkrandd.com)]

A delete button has been added.
Select the wire that is incorrect and go to the edit page, either correct the info or delete it entirely by clicking the "delete" button on the edit wire page.
Each wire can be changed for color, stripe to, or from and even the comments can be changed. Unless its a duped entry, just up date the info, save and away we go!

>-----Original Message-----
>From: Kirsten Jensen [mailto:kirsten@funksoulkitty.org]
>Sent: Sunday, April 9, 2006 12:30 AM
>To: julie@menloparkrandd.com, 'Org, Scirocco'
>Subject: Re: Since its slow....
>
>Looking good, Julie : )
>
>One thing though....what about incorrect info?
>
>I see that there is an entry for a black/violet wire that runs from the 
>fuel pump relay to the fuel pump via the middle of the car.
>
>But that isn't right.....there is a violet/black wire (20 ga) that goes 
>from the fuse panel at F12 to the fuel level sensor which lives under the 
>rear seat. But it has nothing to do with the fuel pump or relay. The 
>other wire that is bundled along with that wire IS for the fuel pump and it 
>is red/yellow (16 ga) and goes from the fuel pump to the T connector in the 
>passenger compartment. The T connector brings the wires for the auxiliary 
>air regulator and control pressure regulator and fuel pump into a single 
>wire which is red/yellow (16 ga) and goes to the fuse panel at 
>A8. Terminal A8 has an internal connection to the fuel pump relay at 
>L14. Incidentally, the Bentley manual has the red/yellow wire listed as 
>black/green...but that is incorrect.
>
>Anyways, just thought I would bring that to your attention....
>
>Kirsten
>backing away slowly.......
>
>
>At 06:26 PM 4/8/2006, julie@menloparkrandd.com wrote:
>>Ok. A few days work and its ready for Beta testing.
>>A complete database designed wiring system for the MKI and MKII Scirocco.
>>
>>A complete readout is available, ordered by the base color of the wire. I 
>>could make a printable version available if you guys think it will be worth it.
>>
>>For searching, select MKI or MKII, then you can search the DataBase by 
>>To/from, to or from and even base wire color and stripe or color or just 
>>stripe. Each wire can be commented for failures, placement, location of 
>>end sensor, what ever.
>>
>>It is set up so any one can add wires OR edit them. Since this is only for 
>>list members, I am going to use the honor system. An Account needs to be 
>>created if you want to add a wire, but the use of the system does not.
>>
>>You can check it out here
>>http://www.menloparkrandd.com/scirocco/wiring/Index.asp
>>
>>Any comments or suggestions are welcome. Seriously. Any help greatly 
>>appreciated! (hell, I dont want to do EVERY wire in a harness :)
>>
>>This system can make diagnosis a LOT easier! I hope Timbo and Brett can 
>>provide a link to their sites. (Please?)
>>Have fun!
>>
>>
>>_______________________________________________
>>Scirocco-l mailing list
>>Scirocco-l@scirocco.org
>>http://neubayern.net/mailman/listinfo/scirocco-l
>
>