Pulling bearing race off hubs?

[ccarpen at earthlink.net (Cris Carpenter)]

I think the easiest way is using an air chisel with a blunt bit.

At 10:52 PM 6/14/2005, you wrote:
>Message: 4
>Date: Tue, 14 Jun 2005 22:31:57 -0500
>From: Scott Rose <slash2@mindspring.com>
>Subject: Re: Pulling bearing race off hubs?
>To: scirocco-l@scirocco.org
>Message-ID: <3.0.3.32.20050614223157.00f76ae8@pop.mindspring.com>
>Content-Type: text/plain; charset="us-ascii"
>
>Anytime I've ever done wheel bearings, I've found that race always wears a
>groove in the hub.  I'd replace the hub.  Should be cheap.
>
>
>
>At 09:39 PM 14-06-05 -0500, you wrote:
> >Anybody got any tricks for removing a wheel bearing race that came off
> >with the hub? I'd rather not get new hubs if I don't have to...
> >
> >Neal
> >'77 Scirocco twin-screw
> >
> >