Engine stand usage

[johncworden at verizon.net (John C. Worden)]

At 05:17 PM 7/21/05, Chad Eatock wrote:

>Hey everyone!  Just picked up an engine stand for the 1.8l.....just 
>wondering how the motor is attached to the stand?  Does it bolt to the 
>block on the flywheel side?  Or does it affix to the belt/pulley 
>side?  I'm so green its sick....but I am slowly getting the motor out of 
>the rocco....jopefully I can have it done before the end of summer!!!!
>
>Chadster16v

Just as Roger said, flywheel side.  I bought threaded rod and thread it 
through the trans to block mounting holes(10mm 1.5 pitch I think?) and
used a nut and washer on the stand side.  Had to use a nut and washer on 
both ends on the one that went through the started bolt hole.

John


-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.323 / Virus Database: 267.9.2/54 - Release Date: 7/21/05