engine Q's 2.0 guts in 1.8 block?

[marc_scirocco at sympatico.ca (marc_scirocco)]

 It might be cheap to get it machined locally.

I'll measure my intermediate shaft tomorrow and will let you know, where and
how much...

Cheers.

Marc

> -----Message d'origine-----
> De : Anson Clement [mailto:ansonivan@yahoo.com] 
> Envoy? : 28 septembre 2004 23:37
> ? : marc_scirocco; scirocco-l@scirocco.org
> Objet : RE: engine Q's 2.0 guts in 1.8 block?
> 
> Ah piss, thats what I was afraid of.... probably cheaper to 
> just buy the real deal.
>  
> Thanks though
>  
> Anson
> 
> marc_scirocco <marc_scirocco@sympatico.ca> wrote:
> 
> 	The intermediate shaft needs to be clearanced as well. 
> The far end diameter
> 	needs to to be machined down.
> 	
> 	Cheers.
> 	
> 	Marc
> 	
> 	
> 	
> 	> Dunno about the intermediate shaft though.
> 	> Dan
> 	> 
> 	> ----- Original Message -----
> 	> From: "Anson Clement" 
> 	> To: 
> 	> Sent: Sunday, September 19, 2004 2:10 PM
> 	> Subject: engine Q's 2.0 guts in 1.8 block?
> 	> 
> 	> 
> 	> > I have a good set of 2.o 16v internals and a 1.8 block 
> 	> which could be 
> 	> > bored. What sort of clearence issues will I encounter.
> 	> >
> 	> > I have heard that the intermediate shaft may need 
> to be turned to a 
> 	> > smaller diameter to clear the rods...
> 	> > dunno if it's true.
> 	> >
> 	> > Just trying to be cheap.
> 	> >
> 	> > anson
> 	> >
> 	
> 	
> 	_______________________________________________
> 	Scirocco-l mailing list
> 	Scirocco-l@scirocco.org
> 	http://neubayern.net/mailman/listinfo/scirocco-l
> 	
> 
> ________________________________
> 
> Do you Yahoo!?
> Yahoo! Mail 
> <http://us.rd.yahoo.com/mail_us/taglines/security/*http://prom
> otions.yahoo.com/new_mail/static/protection.html>  - You care 
> about security. So do we.
>