o2 sensor plug needed

[rapieper at yahoo.com (Ron Pieper)]

M18x1.5 is it.  A bolt and copper washer should do the trick.  The oil drain plug sounds like the
perfect solution.

Probably won't find this tap in a common set, it's a bit out of the ordinary.

HTH

Ron
--- George Herndon <gherndon@eyeontech.com> wrote:

> gordon,
> 
> an 18 x YY sounds about right as that's the same or slightly larger 
> than my expected 3/4" fitting.  i'll check into it when i'm at the 
> parts store later today and report back.  i should also check my tap 
> and die set.  i'm not sure i have a tap that large, but i may.
> 
> -george
>


		
_______________________________
Do you Yahoo!?
Declare Yourself - Register online to vote today!
http://vote.yahoo.com