No Start issue with 1989 Jetta GLI 16v

[jlagnese at massed.net (John S. Lagnese)]

The computer being bad could also cause this.
----- Original Message -----
From: "Jeffrey W. Bynum" <audiodyn@otelco.net>
To: "Marc_Scirocco_Qu?bec" <marc_scirocco@sympatico.ca>;
<scirocco-l@scirocco.org>
Sent: Friday, March 26, 2004 4:10 PM
Subject: Re: No Start issue with 1989 Jetta GLI 16v


> I jumpered the relay, and same result.  I also switched the fuel
distributor
> with another, and same result.  I haven't measured fuel pressure yet.....
> Jeff
>
> ----- Original Message -----
> From: "Marc_Scirocco_Qu?bec" <marc_scirocco@sympatico.ca>
> To: "Jeffrey W. Bynum" <audiodyn@otelco.net>; <scirocco-l@scirocco.org>
> Sent: Friday, March 26, 2004 6:09 PM
> Subject: RE: No Start issue with 1989 Jetta GLI 16v
>
>
> > Fuel pum relay perhaps?
> >
> > Cheers.
> >
> > Marc
> > '83 Scirocco
> > '97 A4
> >
> > > -----Message d'origine-----
> > > De : scirocco-l-bounces@scirocco.org
> > > [mailto:scirocco-l-bounces@scirocco.org]De la part de Jeffrey W. Bynum
> > > Envoy? : vendredi 26 mars 2004 18:55
> > > ? : scirocco-l@scirocco.org
> > > Objet : No Start issue with 1989 Jetta GLI 16v
> > >
> > >
> > > I just purchased this car - 1989 Jetta GLI 16v .  This is the CIS
> > > version, not motronic.  I was told by the PO that the car had a
> > > bad fuel pump.  So I proceed to install a new main pump, and
> > > check the transfer pump. It was suspect so I changed it too.  I
> > > put fresh gas in the car, and a new battery, and proceed to try
> > > and crank the car.  It cranks and runs for like 1 second.  I
> > > deduce that it is cranking and running on the cold start
> > > injector.  I crack open the feed line to the fuel distributor,
> > > and WHOA!, massive amount of pressure and fuel there. Crack open
> > > the cold start line and same there. I crack open the injector
> > > lines, and crank the car, and no fuel comes out there.   I have
> > > checked both pumps, all vacuum lines, hte intake boots, etc, and
> > > all are good.  I even removed the fuel distributor from the
> > > airflow sensor plate and tried manipulating the plunger of the
> > > fuel distributor to simulate the moving of the sensor plate,
> > > still to no avail. So I have fuel to the distributor, nad cold
> > > start injector, but none coming through the distributor and out
> > > to the injectors.  Anyone's insight or knowledge would be appreciated.
> > >
> > > Thanks,
> > > Jeffrey W. Bynum
> > > _______________________________________________
> > > Scirocco-l mailing list
> > > Scirocco-l@scirocco.org
> > > http://neubayern.net/mailman/listinfo/scirocco-l
> > > ---
> > > Incoming mail is certified Virus Free.
> > > Checked by AVG anti-virus system (http://www.grisoft.com).
> > > Version: 6.0.638 / Virus Database: 409 - Release Date: 21/03/2004
> > >
> > ---
> > Outgoing mail is certified Virus Free.
> > Checked by AVG anti-virus system (http://www.grisoft.com).
> > Version: 6.0.638 / Virus Database: 409 - Release Date: 21/03/2004
> >
> >
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l