Oil pan baffle

[sad_rocc at yahoo.com (Dan Smith)]

I vote for the 2nd choice. If you're going to remove the oil pan, it'll take you pretty close to the same amount of time to stick the baffle/gasket in there as it would to stick a new normal gasket in.
 
Dan


Kervin <kervinridgley@earthlink.net> wrote:
Had a nice day today so I was going to put in a oil pan baffle/gasket combo
on my ABA block. Well, there is a kinda factory baffle attached to the oil
pump. Mostly, I just wanted to stop some of the seepage that I was getting
around my current oil pan gasket. Since I do need to get to work in the
morning, I'm think I'll just put the old gasket back on for now.
Should I
1. Just get a simple oil pan gasket and use the factory baffle?
2. Use the baffle/gasket combo and take the baffle off of the oil pump?

Thanks


_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l

---------------------------------
Do you Yahoo!?
Get better spam protection with Yahoo! Mail