Tightening head bolts on engine stand?

[rocco16v at netzero.net (L F)]

Well, ahem, seeing as how the book suggests doing the 180 in two 90degree hits, I'd think +/- 2.5 degrees on each hit would be about all anyone could expect of "eyeball" wrenching.
I know what you guys mean by double checking the book, every time I've done this all I could think was "This is WAY too much!!!"

Larry

  If you position yourself correctly, you can use your foot against the the 
  wheel of the stand that will want to come towards you...  Sometimes this can 
  be easier said than done, but I have done it, and I have seen it done...  As 
  for accurate torque settings, the wrench knows what it is doing.  Just listen 
  for the click.  As for the 180 degrees, I would think that 5 degrees margin of 
  error would be allowable for stretch bolts...  What do you think Larry? 
  (tensed)
  -- 
  Regards,
  David Utley