Rebuilding with molly lub

[rocco16v at netzero.net (L F)]

Cam bearings and lobes
balance shaft bearings
main bearings
rod bearings
piston pins
any other bearings I may have overlooked
(don't forget to prime your new oil pump!)

Larry
  ----- Original Message ----- 
  From: shawn f 
  To: L F 
  Cc: scirocco list 
  Sent: Friday, September 26, 2003 6:49 PM
  Subject: Re: Rebuilding with molly lub


  i was told to only put it on the top part.
    ----- Original Message ----- 
    From: L F 
    To: shawn f ; scirocco list 
    Sent: Friday, September 26, 2003 6:58 PM
    Subject: Re: Rebuilding with molly lub


    Use it everywhere there is a bearing, and on the cam lobes.
    Larry
      ----- Original Message ----- 
      From: shawn f 
      To: scirocco list 
      Sent: Friday, September 26, 2003 7:49 AM
      Subject: Rebuilding with molly lub


      What does everyone think of rebuilding the engine with molly lube? If yes where should i use it. I belive they say use iot on the top of the cam caps not sure where else though.
      _______________________________________________
      Scirocco-l mailing list
      Scirocco-l@scirocco.org
      http://neubayern.net/mailman/listinfo/scirocco-l