[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
cv joints
- Subject: cv joints
- From: Joe.Doty at lcnetwork.com (Joe Doty)
- Date: Mon Sep 8 10:34:25 2003
Personally I got rid of all of those stupid things. I replaced the ones
on the axles with hex headed bolts that I use a open ended 13mm wrench
to remove. The starter bolts got replaced with regular 6mm cap screws
from a rabbit or something.
Joe
-----Original Message-----
From: Dave Ewing [mailto:MK1Scirocco16v@comcast.net]
Sent: Sunday, September 07, 2003 2:34 PM
To: scirocco-l@scirocco.org
Subject: Re: cv joints
Yeah, I know what your saying, John, but the triple square or 12 pt on
the
axles are 6mm. I don't know why your socket says what it does but they
are
6mm. Take a 6mm allen and fit it into the 12 pt bolt, it fits. HTH!
Dave
----- Original Message -----
From: "John C. Worden" <scirocco@powerlink.net>
To: "Dave Ewing" <MK1Scirocco16v@comcast.net>; <scirocco-l@scirocco.org>
Sent: Sunday, September 07, 2003 5:46 AM
Subject: Re: cv joints
> At 08:20 PM 9/6/03 -0700, Dave Ewing wrote:
>
>
> >The triple square is 6mm not 8mm. Audi and the starter bolts take
the
8mm
> >triple square.
> >
> >Dave
>
> All of mine take the 8mm and unless the triplesquare starter bolts are
smaller
> than the allen wrench ones they should take 10mm. Now I'm going by
what
my
> triple squares say on the side-M8 and M10; they do flare down on the
end
maybe
> this is what you are talking about?
> Not looking to start something here, but don't want the guy to buy the
> wrong tool
> either
>
> John
>
_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l