IT LIVES AGAIN!!!

[ansonivan at yahoo.com (Anson Clement)]

If you can reach the dented spot you could try drilling a wee tiny hole in the center of the dent, inserting a long-ish sheet metal screw, and gently pulling with vise grips..... just a thought.
 
Anson

Rhett Farnum <rocco_crossing@hotmail.com> wrote:
I finally got my timing and all working great tonight!!!! It runs 
beautifully except for the clutch is touching the lower bellhousing cover 
when pressed down, because I put a small? dent in it to get to the pan bolt. 
OOPS!! Is there a way to get the lower cover off w/o splitting the engine 
and tranny?
BUT it runs and drive again and I'm happy just with it going about 2 
miles!!!!!!!!! Can you tell I'mhappy w/ all the !!!!!!!!?? OK, I'm done 
now!! what a fiasco though huh!



Peace Out,
Rhett
Rocco_crossing
'83 Rocco (autocross ready, tune up, install harness, and finally I may get 
to makeing it look better!!)

_________________________________________________________________
Compare Cable, DSL or Satellite plans: As low as $29.95. 
https://broadband.msn.com


_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l

---------------------------------
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software