rear wheel bearings

[txrocco at sbcglobal.net (ATS - Patrick Bureau)]

yep, except that you need the vented pads as well (thinner)


ATS - Patrick Bureau - txrocco@sbcglobal.net
----------------------------------------------
MSN:ATSGTX@hotmail.com |YAHOO:ATSGTX@yahoo.com
ICQ:32918816           |AIM:Texasscirocco
----------------------------------------------


=>-----Original Message-----
=>From: scirocco-l-bounces@scirocco.org
=>[mailto:scirocco-l-bounces@scirocco.org]On Behalf Of Dan Smith
=>Sent: Saturday, September 06, 2003 12:36 PM
=>To: Ron Pieper; scirocco-l@scirocco.org
=>Subject: Re: rear wheel bearings
=>
=>
=>Soooooo, for swapping front rotors from solid to vented I just 
=>unbolt the old and on with the new? I hate getting things all 
=>apart and THEN finding out I need some replacement bit or doohickey.
=> 
=>Dan
=>
=>Ron Pieper <rapieper@yahoo.com> wrote:
=>--- Dan Smith wrote:
=>> Is this true for changing front rotors as well (disks)?
=>
=>No! The rear disks actually house the inner and outer bearing 
=>races. The fronts, by way of the
=>lug bolts, simply bolt to a hub which has it's own bearings. 
=>Totally different setup.
=>
=>Ron
=>
=>
=>__________________________________
=>Do you Yahoo!?
=>Yahoo! SiteBuilder - Free, easy-to-use web site design software
=>http://sitebuilder.yahoo.com
=>
=>_______________________________________________
=>Scirocco-l mailing list
=>Scirocco-l@scirocco.org
=>http://neubayern.net/mailman/listinfo/scirocco-l
=>
=>---------------------------------
=>Do you Yahoo!?
=>Yahoo! SiteBuilder - Free, easy-to-use web site design software
=>_______________________________________________
=>Scirocco-l mailing list
=>Scirocco-l@scirocco.org
=>http://neubayern.net/mailman/listinfo/scirocco-l