balancing.

[mardak at cogeco.ca (Mark)]

I don't think they'll be grinding any metal off of the pulleys...  My
guess is that they bolt it together with the crank and material gets
taken off of the crank if it's out...

Mark.
80 S
81 S  ABA/JH/4K

> -----Original Message-----
> From: scirocco-l-bounces@scirocco.org [mailto:scirocco-l-
> bounces@scirocco.org] On Behalf Of shawn f
> Sent: October 28, 2003 12:09 AM
> To: scirocco list
> Subject: balancing.
> 
> Well since my engine build got delayed i decided i should get it
balanced.
> They (the machinist) want my Rod, one set of con rod bearings, one set
of
> rings, The crank, flywheel and bolts, cluch, pressure plate, front
srocket,
> with bolt and pulley. I was wondering i sanblasted (another get air
tool i
> got recently, sand blasting cabinet) the parts pulley and sprocket
that is
> and was wondering if it would be ok to paint these parts. Just
wondering
> if they mind i guess it doesnt matter. Problem i was thinking is if
they
> have to grind some of the parts there goes the paint. I guess i can
touch
> any areas ground down. But then that may throw it out of balance
again.
> Anyone know how much redline i can expect. I relize that i still need
a
> better cam and stronger springs in the future, but when i get some
good
> springs what redline can i expect. Any things i should stress with the
> machine shop? Any advice would be great...
> 
> Shawn F
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l