[tech][16v] OXS help

[ralexander03 at snet.net (Rick Alexander)]

There are "test" connections in this area that do not connect to anything.
The O2 sensor has a two place plug and a single spade connector. The single
is the sensor output and goes into a shielded probably green wire. The other
connector is the heater and should only plug into one of the remaining
connections.

Rick Alexander

----- Original Message -----
From: "Chris M" <ctmscirocco@hotmail.com>
To: <scirocco-l@scirocco.org>
Sent: Saturday, May 10, 2003 9:10 PM
Subject: [tech][16v] OXS help


> Hi all,
>   I'm retrofitting a Haltech F9a to my 16v right now and I need to hook up
> an A/F meter to the O2 sensor.  I'm looking at what I assume is the O2
> connector and it doesn't correspond to my bentley.  The plug I found is
> right behind the throttle body and has a 2 place male connector with 2
white
> wires, and a black wire hooked to a female spade plug, all in the same
loom.
> Does any of this ring a bell with anybody?  I took about a thousand
pictures
> of this thing while I was taking it apart, but of course, I have none of
> this connector.  Any help would be really appreciated.
>
> TIA!
>
> Chris M.
> 82 8v Scirocco (RIP)
> 88 16v Scirocco
> 70 MGB (wife's car)
> 76 Chevy Laguna
> http://www.geocities.com/vw16vmp3scirocco/
> ctmetzger@hotmail.com
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l