hot engine after-run circuit

[ralexander03@snet.net (Rick Alexander)]

There is one sensor on the drivers side of 16v heads that is not used. Could
be why you can't find a wire that goes to it.

Rick Alexander

----- Original Message -----
From: "Allyn" <amalventano@sc.rr.com>
To: "scirocco list" <scirocco-l@scirocco.org>
Sent: Saturday, March 15, 2003 11:36 PM
Subject: hot engine after-run circuit


> when i put the 2.0 in the rieger i was left scratching my head when
> reconnecting one of the wires. on the right side of the head there are 4
> senders. the 2 bottom ones are easy (color coded plugs), the upper rear is
a
> tab that sticks out (also easy, since there is only one plastic covered
> connector for that as well). the upper front is a flat disc thats meant to
> take a typical crimp connector type plug, only sideways. the catch is that
> there is another one of these same flat discs at the rear right side of
the
> head, yet i have only one connector to put on. im fairly certain the wire
is
> to the after-run circuit, but the bentley gets really sketchy when it
talks
> about this circuit. i cant find the wire in the schematics, and cant find
a
> physical head-sensor layout in there either. has anyone figured out what
> goes where as far as these single wire connections go?
> Al
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>