[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Is there a trick to removing the retaining clips holdingthe clutch lever in?
- Subject: Is there a trick to removing the retaining clips holdingthe clutch lever in?
- From: flaatr at yahoo.com (Euroroc II)
- Date: Fri Jun 20 11:31:05 2003
- In-reply-to: <00f701c3373e$62d1c300$5a554f0a@TVSIT02>
Ya don't need to do all that... remove the block on the arm (clutch lever
arm) that keeps it from going too far down and then swing it all the way
down... you should be able to get to the throw out bearing now...
-Raffi
At 08:12 AM 6/20/2003 -0700, Jeff Toomasson wrote:
>Towards the end of my session last night, I pulled off the tranny end cap
>to remove the clutch lever to replace the release/pushrod bearing. I
>tried to get these clips off using a needle-nose but I quickly found out
>that this is probably NOT the way to do it.
>
>Do I need a special tool? Or just more patience?! :)
>
>TIA, JT
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l