A little taste of what I'm cookin

[bennyb2k4 at sympatico.ca (Ben Beacock)]

I just finished re-spacing the throttle bodies.  They were originally
80mm apart and need to be 88mm.  Next step is to fill a bit of the lower
manifold with weld to make a smooth transition then weld on the flanges.
The throttle bodies conveniently come with a rubber mount that
transitions from a circle to an oval shape like the lower manifold but
its slightly smaller.

Ben
81 Scirocco 2L16V EFI

-----Original Message-----
From: scirocco-l-bounces@scirocco.org
[mailto:scirocco-l-bounces@scirocco.org] On Behalf Of koabi
Sent: July 8, 2003 11:43 AM
To: bbeacock@rogers.com; 'Scirocco. org Mailing List'
Subject: RE: A little taste of what I'm cookin

Can I have a bite?

What's left to work out with that setup?

koabi

-----Original Message-----
From: scirocco-l-bounces@scirocco.org
[mailto:scirocco-l-bounces@scirocco.org] On Behalf Of Ben Beacock
Sent: Tuesday, July 08, 2003 7:29 AM
To: Scirocco. org Mailing List
Subject: A little taste of what I'm cookin

http://www.vwot.org/community/modules/Gallery/albums/albuo65/0020_G.jpg

I'm hoping to have these done for Waterfest.  If it works as planned, I
might be able to make them for significantly less than TWM or Badger 5.

Ben
81 Scirocco 2L16V EFI (soon ITB!)


_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l



_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l