[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

OT Headgasket job prob



This may be it! There is a different mark on the back. It does appear to
line up with TDC! I'm heading out to the garage to change to the right mark.
I'll keep everyone posted.
John
----- Original Message -----
From: "Nate Mellom" <bronson@inwave.com>
To: "John Lagnese" <jlagnese@massed.net>; "Scirocco list"
<scirocco-l@scirocco.org>
Sent: Sunday, February 23, 2003 10:03 PM
Subject: Re: OT Headgasket job prob


> John,
> I don't know about newer 1.8s, but when I installed my new motor in my
> '84 I couldn't get anything, just like you.  I found out (after looking
> at a few books) that I was supposed to use the INSIDE timing mark, line
> it up with the upper edge of the head.  I found my mistake and she fired
> right up!
> As far as your spark plugs being backwards, I had a similar instance
> when I replaced the distributor in my '81.  When you installed your
> timing belt, did you line up the intermediate shaft notch/crank pully
> notch, etc?  I suspect that you've thrown out your timing 180*.  Check
> and make sure every thing is lined up again.
> HTH!
> Nate
>
> --
> "It is far better to be well fed, moderately wealthy, in good health,
abundantly cheerful, victorious and well regarded than poor, sick, sad,
defeated and obscure"
>     -Poor Richard
>
>
>
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l