[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

need part #

Well! I guess that settles that!

----- Original Message -----
From: "ATS - Patrick Bureau" <txrocco@sbcglobal.net>
To: "Dan Bubb" <jdbubb@ix.netcom.com>; "Drew MacPherson"
<drew@scirocco.cs.uoguelph.ca>
Cc: "_Scirocco Mailing List" <scirocco-l@scirocco.org>
Sent: Friday, August 08, 2003 10:23 AM
Subject: RE: need part #


> Alright you had to get me in the garage at 8 am on a friday morning eh!
well
> here is what I have discovered.
>
> these are 1 engine 1.8 JH from 84 and 85 scirocco
>
> First this one orientates the plate location
> <http://longcoeur.com/scirocco/various/P8080186.JPG>
>
> Second is the plate removed (yes there is a hole behind it!)
> <http://longcoeur.com/scirocco/various/P8080187.JPG>
>
> BUT!
> I discovered after removing the plate that the JH in 85 did not have a
> gasket like the other JH in 84 (plate is also different - vw does it
again)
> The 84 plate was flat in the back with a gasket... but my 85, well it has
an
> O-RING incased in the plate check it out!
>
> <http://longcoeur.com/scirocco/various/P8080189.JPG>
>
>
> Any other questions I can answer visually for you ???
>
> ATS - Patrick Bureau - txrocco@sbcglobal.net
> ----------------------------------------------
> MSN:ATSGTX@hotmail.com |YAHOO:ATSGTX@yahoo.com
> ICQ:32918816           |AIM:Texasscirocco
> ----------------------------------------------
>
>
> =>-----Original Message-----
> =>From: scirocco-l-bounces@scirocco.org
> =>[mailto:scirocco-l-bounces@scirocco.org]On Behalf Of Dan Bubb
> =>Sent: Friday, August 08, 2003 8:55 AM
> =>To: Drew MacPherson; ATS - Patrick Bureau
> =>Cc: _Scirocco Mailing List
> =>Subject: Re: need part #
> =>
> =>
> =>Not only the diesel, but I believe 1.6 and 1.7 gas engines had a
> =>hole in the
> =>block where the fuel pump was mounted if the car had a
> =>carburetor. When they
> =>went to CIS they just put a blockoff plate over the hole.
> =>ETKA tends to reuse graphics if they even remotely show the situation,
so
> =>the accuracy of the sketch can't be counted on too much.
> =>Dan
> =>
> =>----- Original Message -----
> =>From: "Drew MacPherson" <drew@scirocco.cs.uoguelph.ca>
> =>To: "ATS - Patrick Bureau" <txrocco@sbcglobal.net>
> =>Cc: "_Scirocco Mailing List" <scirocco-l@scirocco.org>
> =>Sent: Friday, August 08, 2003 9:34 AM
> =>Subject: RE: need part #
> =>
> =>
> =>>
> =>> Not meaning to offend Patrick, but that picture is actually a 1.6L
> =>> Diesel/TD block - note the oil squirters?
> =>>
> =>> The blockoff plate seen at (9) is the diesel blockoff plate.
> =>>
> =>> Reference JEG 86:1:03:3-00 - you'll note that it's the same picture,
but
> =>> the 1.8 block is the bottom one, the 1.6D/TD is the top one.
> =>>
> =>> There's no indication of a gasket on the 1.8, although there is
> =>a hole in
> =>> the picture.
> =>>
> =>> Drew
> =>>
> =>>
> =>> On Fri, 8 Aug 2003, ATS - Patrick Bureau wrote:
> =>>
> =>> > Hey old 16v dudes... listen up (oh I do love mornings like theses)
> =>> >
> =>> > Actually on the JH engine, the warm up regulator unit sit on a plate
> =>that
> =>> > itself sits on a gasket that is bolted with 2 hex screws.
> =>> > See picture on and look at item #9
> =>> > <http://longcoeur.com/scirocco/various/blockjh.jpg>
> =>> >
> =>> > now the problem is that there is no part number anymore.
> =>> >
> =>> > Dan if you need one, and your old one is too mangled to make a copy
> =>(from
> =>> > single sheet gasket that you can buy at AutoZone) I have one unused,
I
> =>can
> =>> > trace it out for ya on a square of the proper material, and
> =>mail to you
> =>if
> =>> > you like. or scan it for you to print and cut up.. either way LMK.
> =>> >
> =>> > ATS - Patrick Bureau - txrocco@sbcglobal.net
> =>> > ----------------------------------------------
> =>> > MSN:ATSGTX@hotmail.com |YAHOO:ATSGTX@yahoo.com
> =>> > ICQ:32918816           |AIM:Texasscirocco
> =>> > ----------------------------------------------
> =>> >
> =>> >
> =>> > =>-----Original Message-----
> =>> > =>From: scirocco-l-bounces@scirocco.org
> =>> > =>[mailto:scirocco-l-bounces@scirocco.org]On Behalf Of Dan Bubb
> =>> > =>Sent: Friday, August 08, 2003 7:21 AM
> =>> > =>To: Dan Smith; scirocco-l@scirocco.org
> =>> > =>Subject: Re: need part #
> =>> > =>
> =>> > =>
> =>> > =>I could be wrong, but I don't believe there is a gasket under the
> =>warmup
> =>> > =>regulator/control pressure regulator. I don't think the JH has a
> =>> > =>hole in the
> =>> > =>block in this location. Or at least ETKA doesn't show it or any
> =>gasket.
> =>> > =>The ABA and PL have breather holes in the block, but not the JH.
> =>> > =>Shoot me if I'm wrong.
> =>> > =>Dan
> =>> > =>
> =>> > =>----- Original Message -----
> =>> > =>From: "Dan Smith" <sad_rocc@yahoo.com>
> =>> > =>To: <scirocco-l@scirocco.org>
> =>> > =>Sent: Friday, August 08, 2003 2:32 AM
> =>> > =>Subject: need part #
> =>> > =>
> =>> > =>
> =>> > =>> I need the part number for a gasket (ETKA part number that is).
> =>> > =>Ok, let me
> =>> > =>try to describe it.... Above and to the left of the oil
> =>filter/sender
> =>unit
> =>> > =>is the fuel control pressure regulator or something like that. It
> =>> > =>has 2 fuel
> =>> > =>lines going into it and connects to the block. I need the
> =>seal that is
> =>> > =>inbetween that and the block, I believe it's where the block-off
> =>> > =>plate would
> =>> > =>go. This is for an 84 mk2 8v, JH engine. Hopefully you know what
> =>> > =>I'm talking
> =>> > =>about as I need to call a stealership tommorrow to make
> =>sure they have
> =>it.
> =>> > =>Also, is it pronounced E.T.K.A. or ET (like let without the 'L')
KA?
> =>> > =>>
> =>> > =>> TIA,
> =>> > =>> Dan
> =>> > =>>
> =>> > =>>
> =>> > =>> ---------------------------------
> =>> > =>> Do you Yahoo!?
> =>> > =>> The New Yahoo! Search - Faster. Easier. Bingo.
> =>> > =>> _______________________________________________
> =>> > =>> Scirocco-l mailing list
> =>> > =>> Scirocco-l@scirocco.org
> =>> > =>> http://neubayern.net/mailman/listinfo/scirocco-l
> =>> > =>
> =>> > =>
> =>> > =>
> =>> > =>_______________________________________________
> =>> > =>Scirocco-l mailing list
> =>> > =>Scirocco-l@scirocco.org
> =>> > =>http://neubayern.net/mailman/listinfo/scirocco-l
> =>> >
> =>> >
> =>> > _______________________________________________
> =>> > Scirocco-l mailing list
> =>> > Scirocco-l@scirocco.org
> =>> > http://neubayern.net/mailman/listinfo/scirocco-l
> =>> >
> =>>
> =>> --
> =>> /=============================================\
> =>> |  84 Wolfsburg Edition TurboDiesel Scirocco  |
> =>> |    http://scirocco.cs.uoguelph.ca/gtd       |
> =>> \=============================================/
> =>>
> =>>
> =>> _______________________________________________
> =>> Scirocco-l mailing list
> =>> Scirocco-l@scirocco.org
> =>> http://neubayern.net/mailman/listinfo/scirocco-l
> =>
> =>
> =>
> =>_______________________________________________
> =>Scirocco-l mailing list
> =>Scirocco-l@scirocco.org
> =>http://neubayern.net/mailman/listinfo/scirocco-l
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l