Drive Flange Seals

[scirocco@powerlink.net (John C. Worden)]

--=======173B1ED0=======
Content-Type: text/plain; x-avg-checked=avg-ok-25DB6940; charset=us-ascii; format=flowed
Content-Transfer-Encoding: 8bit

At 10:48 AM 10/23/02 -0400, broke wrote:

>I used 2 wrenches as the special tool. Laid them on the flange on each side
>of the shaft, then a bolt with a washer and various spacers (the bolt was
>too long, I needed to take up some threads) went between them, and into the
>flange. Then I used flatblade screwdrivers to work the clips on and off.
>
>Broke
>
>
> >
> > It's not so bad, if you have or fabricate a tool for the CV flanges. The
>toughest part is getting the C clips back on.
> >

Circlip pliers are a great tool to have, if only just for this.  They 
aren't expensive either.

John

--=======173B1ED0=======--