Front Lower Stress Bar bolt Pattern?

[brianm@earendel.org (Brian McGarvey)]

There is a way to do it.
#1 You can do it the way I did, By removing the
engine and drilling the holes. I was also doing an engine swap.

#2 Find a 16v and measure where the holes are.

#3 make a mold of a 16v lower and drill thru the hole

#4 construct a jig shaped like a capital C you kknow like using a Cclamp
with points instead of flats to mark and drill it.

#5 insert imagination.

Brian
82 2.0L bunny.. with a K-bar.


On Wed, 12 Jun 2002, Ken Bates wrote:

> Rick,
> I have the same 'dilema'.  Ill be watching this thread.  Your talking about
> the bar that is stock 16v right?  Shaped kinda like a "K"?
>
> Ken
> '79 Scirocco 16v project "McFly"
> "...it's working...It's Working...!!"
> '86 16v (parts car)
> VORTEX:  "Indiana Red"
>
> ----- Original Message -----
> From: "Rick Kellner" <rfkellner@snet.net>
> To: <scirocco-l@scirocco.org>
> Sent: Wednesday, June 12, 2002 5:35 AM
> Subject: Front Lower Stress Bar bolt Pattern?
>
>
> >   I picked up a stock, front lower stress bar from a 16v Scirocco that I
> > want to put on my 84 8v.  Since this was not a stock component for my car
> I
> > will need to drill two holes for the back mounts.  Since the bar mounts on
> > top there is no way to drill accurately from the bottom.
> >        Does anyone have a diagram they could scan or fax showing the bolt
> > pattern?  Any suggestions?  Thanks Rick Kellner.
> >
> >
> >
> > _______________________________________________
> > Scirocco-l mailing list
> > Scirocco-l@scirocco.org
> > http://neubayern.net/mailman/listinfo/scirocco-l
> >
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>