ABA swap parts

[krobins2@twcny.rr.com (Kenneth & Georgianna Robinson)]

Hey,Kervin;I believe these are the parts & things you have left out of your
"list":
1a: either dist. gear & dist. body adapter for using your ign. dist.in block
of ABA,or:
1b: an complete Audi 80 ign. dist.
2: instead of using block off plate,I would tee the extra vent tube into the
existing PCV system(like I did)
3: oil pump for solid lifter engine(DON'T use ABA pump in a solid lifter
head/ABA swap!!!!!)
4: get the correct head gasket set for your Rocco,and order extra head
gasket;either 2.0L 3A/9A H.G.(same part),or metal head gasket for a ABA
5: comp. engine compartment harness for an already K.S. equipped Rocco(or
other suitable dub)
6: transfer belt pulleys from your old block to ABA.You MUST use 2.0L ABA
timing belt!!!!('cause ABA block is 16mm higher)
7a: either use old E/M & D/P with spacer between D/P & E/M('cause ABA is
16mm higher),OR.....
7b: use D/P & E/M from ABA,or special made one from TT just for this purpose
8: forget most of this stuff,and use 3A block from Audi 80(like I did),much
less complicated;and it'll already have the right ign. dist. in it!
9: a case of your favorite beer,to go with those M&M's(only 2 bags????)
LMK if you have any other questions.........hehehe.......
Ken R.
----- Original Message -----
From: "Kervin" <kervinridgley@earthlink.net>
To: "List" <scirocco-l@scirocco.org>
Sent: Monday, June 03, 2002 9:10 PM
Subject: ABA swap parts


> I'm finally going to have the time and money to do my ABA swap.  I have
> 150,000 miles on the engine and drivetrain now, so i want to change the
> stuff to make it like new again.  If there is anything that you think I
> missed, please let me know.  I'm placing my order in a week.  Thanks.
>
> 1.8-2.0 8v Head Gasket Kit
> 210mm lightened Flywheel
> 8v 210mm Clutch Disc
> 8v Bolt/seal kit for clutch
> A1 park brake cable
> left side motor mount
> heavy duty or motorsport rear tranny mount
> 2 bags of peanut M&M's
> clutch cable rubber washer
> clutch tool
> 4 cam/gear seals
> rear main seal
> manual clutch cable
> steering column bearing
> water pump w/ housing
> valve adjusting pliers
> valve depressor tool
> Coolant
> Redline Gear oil
> Oil change stuff
> Knock sensor set-up
> Block off plate for ABA
>
> --
> Kervin
> 80 1.7 8v Ole Paul
> 82 1.7 8v The gift
> 86 1.8 8v My everyday ride
> 00 tt600
> icq# 154814286
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>