HELP NEEDED ASAP!!! ARP rod bolts...

[joshhignight@techography.net (joshhignight@techography.net)]

These are rod studs. They aren't 10mm (too big), nor are they 9mm (too small). 3/8 is too large, but 5/16 is too small. Next up is 11/32 if I'm thinking right (or 9.5mm, if such a thing exists). 

Joshua


Original Message -----------------------
I am not sure, but I do believe the ARP bolts kit heads are metric size,
most likely a 13 no ?

==========================================
ATS - Patrick Bureau
ATS - Patrick Bureau
1985 8v **Planning 3A/JH  Upgrade**
1985 8v  ** Titian Project **
1988 16v ** Sold **
Web Site : http://longcoeur.com/scirocco


=>-----Original Message-----
=>From: scirocco-l-admin@scirocco.org
=>[mailto:scirocco-l-admin@scirocco.org]On Behalf Of
=>joshhignight@techography.net
=>Sent: Saturday, July 20, 2002 8:56 AM
=>To: Scirocco List
=>Subject: HELP NEEDED ASAP!!! ARP rod bolts...
=>
=>
=>   I'm in the process of trying to fix my block (pistons rotated
=>180* from where they should be). It has ARP rod bolts. I can't
=>find a wrench to fit the rod bolt nuts (I'm thinking 11/32 8
=>point, but not sure). Also, I need to know the torque spec to
=>tighten them back to as well. If anyone can help, please reply ASAP!
=>
=>Thanks.
=>
=>
=>_______________________________________________
=>Scirocco-l mailing list
=>Scirocco-l@scirocco.org
=>http://neubayern.net/mailman/listinfo/scirocco-l