16V wiring

[rick@brubakerbox.com (Rick Alexander)]

I can't seem to get e-mail through my ISP to Scirocco-l@scirocco.org  at the
moment so please forward this to the list.

Picture http://www.brubakerbox.com/temp/MVC-759F.jpg shows those
connections. When I asked this very question last week, the replies were
that the upper left is not connected to anything. The upper right is the
water temp gauge. The lower right is the thermo time switch. The lower left
is coolant temp sensor for the injection.

That and the Bentley will get you hooked up.

Rick Alexander
http://www.brubakerbox.com
http://clubs.hemmings.com/hams/
http://clubs.hemmings.com/vwsrus/

----- Original Message -----
From: "Ken" <mcfly67@qwest.net>
To: "Scirocco List" <scirocco-l@scirocco.org>
Sent: Monday, January 21, 2002 4:12 PM
Subject: 16V wiring


> The Bentley shows terminal D29 as a red/ylw wire going to the coolant temp
> sender.  Which of the male "spade" connectors is that on the block.  There
> are 3 at the dist end left/right and below (roughly) the Dist.  These 3
are
> unused/accounted for so far in my reinstall.  Help anyone?
> Cant find a good pic in the bently of which is which.
> Thanks
> Ken
> 1979 Scirocco  "McFly"
> 16v conversion - Engine in, now the hard part
> Electrical  : (
> VORTEX:  "Indiana Red"
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>