Possible Parts FS

[jerry.carter@shaw.ca (Jerry Carter)]

I'd peg it at 12% intrested, if I knew that that setup ran, and would fit in
my car. it might get higher if I knew the cost, but I don't think it could
get lower than that (unless you'd be askin' like $3000). remember cost ahs a
lot to do with intrest.

Jerry Carter
'81 Scirocco
----- Original Message -----
From: <WaspHwy@aol.com>
To: <scirocco-l@scirocco.org>
Cc: <mk1gti@egroups.com>
Sent: Tuesday, January 08, 2002 12:25 PM
Subject: Possible Parts FS


> I am just guaging interest in these things:
>
> NEW audi 3a:
> block bored .030 over and decked .003
> new intermediate shaft bearings and main bearings
> Wiseco forged allum. pistons (.030 over)
> polished,balanced, blueprinted, rebushed audi rods
> polished (standard) crank
> 1.8 solid lifter head with either new Schrick 280 asy., used Schrick 276
> asy., or new G grind, ported, polished, 5 angle valve job, new guides
seals
>
> some other things too
> lmk
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l