[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

how to unsubscribe



>> HOW TO UNSUB FROM THIS LIST YOURSELF
> 
> 
> First, ask your Internet Provider to mail you an Unsubscribing Kit.
> Then follow these directions.
> The kit will most likely be the standard no-fault type. Depending
> on requirements, System A and/or System B can be used. When
> operating System A, depress lever and a plastic dalkron unsubscriber
> will be dispensed through the slot immediately underneath. When you
> have fastened the adhesive lip, attach connection marked by the
> large "X" outlet hose. Twist the silver- coloured ring one inch
> below the connection point until you feel it lock.
> The kit is now ready for use. The Cin-Eliminator is activated by
> the small switch on the lip. When securing, twist the ring back to
> its initial condition, so that the two orange lines meet.
> Disconnect. Place the dalkron unsubscriber in the vacuum receptacle
> to the rear. Activate by pressing the blue button.
> The controls for System B are located on the opposite side. The red
> release switch places the Cin-Eliminator into position; it can be
> adjusted manually up or down by pressing the blue manual release
> button. The opening is self- adjusting. To secure after use, press
> the green button, which simultaneously activates the evaporator and
> returns the Cin-Eliminator to its storage position.
> You may log off if the green exit light is on over the evaporator .
> If the red light is illuminated, one of the Cin-Eliminator
> requirements has not been properly implemented. Press the "List
> Guy" call button on the right of the evaporator . He will secure
> all facilities from his control panel.
> To use the Auto-Unsub, first undress and place all your clothes in
> the clothes rack. Put on the velcro slippers located in the cabinet
> immediately below. Enter the shower, taking the entire kit with
> you. On the control panel to your upper right upon entering you
> will see a "Shower seal" button. Press to activate. A green light
> will then be illuminated immediately below. On the intensity knob,
> select the desired setting. Now depress the Auto-Unsub activation
> lever. Bathe normally.
> The Auto-Unsub will automatically go off after three minutes unless
> you activate the "Manual off" override switch by flipping it up.
> When you are ready to leave, press the blue "Shower seal" release
> button. The door will open and you may leave. Please remove the
> velcro slippers and place them in their container.
> If you prefer the ultrasonic log-off mode, press the indicated blue
> button. When the twin panels open, pull forward by rings A & B.
> The knob to the left, just below the blue light, has three settings,
> low, medium or high. For normal use, the medium setting is
> suggested.
> After these settings have been made, you can activate the device by
> switching to the "ON" position the clearly marked red switch. If
> during the unsubscribing operation, you wish to change the settings,
> place the "manual off" override switch in the "OFF" position. You
> may now make the change and repeat the cycle. When the green exit
> light goes on, you may log off and have lunch. Please close the
> door behind you