taking drive flange off

[Joe.Doty@lcnetwork.com (Joe Doty)]

I think the shaft is M10x1.5...Meze knows for sure...you're gonna have
to make a tool to compress the drive flange towards the transmission in
order to get the circlip off.

Also, GET A CIRCLIP TOOL.  It will make your life ten thousand times
easier...you'll see if you try to get one off with a pair of
screwdrivers, or needle nose pliers.

Joe Doty
IT/Development
joe@lcnetwork.com=20

-----Original Message-----
From: rhys [mailto:sik8v@netscape.net]=20
Sent: Wednesday, December 11, 2002 4:40 PM
To: scirocco-l
Subject: taking drive flange off

i'm gonna pull the drive flange tomorrow, as the seal was leaking quite=20
a bit.

what do i need to make the tool to pull it off (size, pitch of bolt)? or

is there somewhere i can buy it?

thanks



_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l