Transmission mount question

[Larry" <rocco16v@netzero.com (Larry)]

My experience has been in agreement with Al's.  I know the Bentley gives
some vague instructions on "mount alignment", but, other than the small
vertical movement possible in the front mount, I see no way to adjust any of
them short of elongating some holes with a rattail file......

Larry
----- Original Message -----
From: Allyn <amalventano1@comcast.net>
To: Wes Brockway <kywes@bellsouth.net>; <scirocco-l@scirocco.org>
Sent: Monday, April 01, 2002 4:00 PM
Subject: Re: Transmission mount question


> Should be all good as long as you didnt twist the rear mount any. I've
never had one not line up to
> the point where i had to rock the motor.
> Al
>
>
> ----- Original Message -----
> From: "Wes Brockway" <kywes@bellsouth.net>
> To: <scirocco-l@scirocco.org>
> Sent: Monday, April 01, 2002 6:16 PM
> Subject: Transmission mount question
>
>
> > Today I replaced the front engine mount and the transmission mount on my
> > '87 16V. Much nicer as the tranny mount had completely torn in two. I
> > think I remember reading somewhere that after installing the mounts and
> > before completely tightning them done that one should rock the
> > motor/tranny, or something to let the mounts settle.
> >
> > Any feedback on this. It was late in the day and I was tired so I just
> > tightened them on down.
> >
> >
> >
> > _______________________________________________
> > Scirocco-l mailing list
> > Scirocco-l@scirocco.org
> > http://neubayern.net/mailman/listinfo/scirocco-l
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>