Re: Removing steering rod end From HUB

["Ken" <mcfly67@qwest.net>]

When I did this i used a puller.  The claw part kept wanting to slip odd but
after a few tries...
Also a trick is to hit each side of the joint w/ a hammer and the rod end
will pop out.  Its in my "how to keep your VW alive" book by John Muir.
Ken
1979 Scirocco  "McFly"
16v conversion - Engine in, now the hard part
Electrical  : (
VORTEX:  "Indiana Red"
----- Original Message -----
From: T Berk <tberk@mindspring.com>
To: Scirocco List <scirocco-l@scirocco.org>
Sent: Friday, November 30, 2001 4:16 PM
Subject: Removing steering rod end From HUB


>
>
> Do I really need one of those 'pickle forks"? Or is there another way?
>
> Car in question is an A2 GTI to Jetta hub swap but eventually I will be
> replacing the ends on the Roc too so any help, technique would be
> helpful.
>
> TBerk
>
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to
majordomo@scirocco.org
>
>


--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org