[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [PART NEEDED] Front Motor Mount Bracket -and more-



Jason,
    As I am swapping engines, I'll bet I have an extra one of those now.
I'll check.  You can have it if I can find it.  The other response was
better though probly.  A "yard" would be a few days quicker for you.  LMK
On that note:
MY front mount is not lining up quite right.  The bracket on the engine is
attached and square and the new rubber mount TT sent me w/ the cat-back.
Everything fits together good but the bracket that goes on the rad support
is about 1/2 or 3/4" to low when oriented flat/flush to the rad support.
Any ideas?
All other mounts are in but not torqued.  Though I am getting that way.

Ken
1979 Scirocco "McFly"
In the middle of the 16v conversion
VORTEX "Indiana Red"

----- Original Message -----
From: Jason F. Snow <jason87vw@hotmail.com>
To: scirocco-mail list <Scirocco-L@scirocco.org>
Sent: Tuesday, November 20, 2001 12:55 PM
Subject: [PART NEEDED] Front Motor Mount Bracket


> Hey Gang,
>
> I finally put my engine in this weekend!!! Woohoo! BUT I am missing the
> bracket that mounts on the the radiator support. I need the bracket, the
> two bolts (I think they're 19MM) AND the washers. This sucks! Can anyone
> help ? I hate to go to the stealership for this.
>
> Thanks,
>
> Jason F. Snow
>
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to
majordomo@scirocco.org
>
>



--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org