[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

My new exhaust!



-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

I got my whole new exhaust in yesterday, thank you everyone for the
helpful advise on the o2 sensor, and the exhaust in general. I have
to say I amazed by how quiet the whole system is. I have the 2.25" TT
stainless downpipe/cat with the matching exhaust pipe and a stainless
Borla muffler, and it is quieter than the stock exhaust!

One more question however:

Is the exhaust going to settle downward over the next few days as the
rubber hangers settle into place? The reason I ask is because I spent
quite a bit of time adjusting the fit of the exhaust pipe to get
maximum clearance, took it on several test drives and adjusted again,
and still there is one spot that very occasionally makes a slight
rattle as in just barely rubs on the undercarriage. I have adjusted
as much as it can be, and there is simply no way I can get any more
clearance in that one spot without causing it to rub somewhere else.
As I said, it normally doesn't rub, and with the car off it seems to
have plenty of clearance everywhere, but under some circumstances I
still get a slight "brrr" from this one bit. Even if the whole thing
only settled an 1/8" that would probably be enough to clear
everything.

Any ideas?







The goal is to overcome the deliberate nature of the process. 

-----BEGIN PGP SIGNATURE-----
Version: PGPfreeware 6.5.8 for non-commercial use <http://www.pgp.com>

iQA/AwUBO+GgIQO3tw2TqB1hEQKn4gCfTqwhBTA6vbZqdVe9Goi3RVDdF+gAn0W/
2lebUgDvah4p6sMVSRpmV4Ho
=k7fi
-----END PGP SIGNATURE-----


--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org